Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
1.1. Description of the car
1.2. Dashboard, governing bodies and combination of devices
1.3. System of heating and air conditioning
1.4. Use of the car to destination
1.5. Elimination of the malfunctions which arose in way or before a start of motion
1.5.1. If the car is not started
1.5.2. Onboard tool, jack and spare wheel
1.5.2.1. Spare wheel
1.5.2.2. Removal of a decorative cap of a wheel (for cars with steel disks)
1.5.2.3. Installation of a jack
1.5.2.4. Replacement of wheels
1.5.3. Towage of the car
1.6. Maintenance of the car
1.7. Tables
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

1-5-2-2-snyatie-dekorativnogo-kolpaka-kolesa-dlya-avtomobilejj-so-stalnymi-diskami.html

1.5.2.2. Removal of a decorative cap of a wheel (for cars with steel disks)

Fig. 1.149. Removal of a decorative cap


Take off a decorative cap of a wheel (fig. 1.149).

Fig. 1.150. Weakening of an inhaling of nuts of fastening of a wheel


Take off a decorative cap of a wheel by means of the slanted end of a wheel wrench, as shown in the figure 1.150.
Weaken all nuts of a wheel.
Always weaken wheel nuts before a car raising.
To weaken wheel nuts, rotate them counterclockwise. to receive the maximum effort, establish a key on a nut so that the handle appeared on the right, as shown in the drawing above. Take a wrench near the end of the handle and pull for the handle up. You watch that the key did not come off a nut.
At this stage do not remove a nut but only unscrew them approximately half way.

ATTENTION
Never you apply oil or lubricants on bolts or nuts. It can lead to weakening of nuts and a detachment of wheels and to become the reason of serious accident.

"previous page
1.5.2.1. Spare wheel
following page"
1.5.2.3. Installation of a jack