Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.2.1. General information and safety measures on removal of the power unit
2.2.2. Removal of sealant
2.2.3. The specification of types of the applied nuts and bolts
2.2.4. Service of a mechanical part of the engine
2.2.5. General repair operations
2.2.5.1. Removal of an oil filter
2.2.5.2. Removal of a pulley of a bent shaft
2.2.5.3. Removal of the pump of cooling liquid
2.2.5.4. Removal of the oil pallet
2.2.5.5. Dismantling of working components of the drive of the mechanism of gas distribution
2.2.5.6. Removal of a chain of the drive of the oil pump
2.2.5.7. Removal of the oil pump
2.2.5.8. Removal of covers and bearing of the camshaft
2.2.5.9. Removal of a head of the block of cylinders, check of an axial side play of balancer shafts
2.2.5.10. Check of a radial side play of balancer shafts
2.2.5.11. Removal of balancer shafts
2.2.5.12. Replacement of a back epiploon of a bent shaft
2.2.5.13. Check of a chain of the drive of the mechanism of a gazorspredeleniye and asterisk of shaft
2.2.5.14. Check of work of a natyazhitel of a chain of the mechanism of a gazorspredeleniye
2.2.5.15. Check of a beating of a cam-shaft
2.2.5.16. Check of height of a cam of a cam-shaft
2.2.5.17. A gap in cam-shaft necks (outer diameter of a neck of a cam-shaft)
2.2.5.18. Installation of an asterisk of WT (camshaft of inlet valves)
2.2.6. Dismantling, check and assembly of a head of the block of cylinders
2.2.7. Dismantling, check and assembly of the block of cylinders
2.2.8. General assembly
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-2-5-12-zamena-zadnego-salnika-kolenchatogo-vala.html

2.2.5.12. Replacement of a back epiploon of a bent shaft

Fig. 2.72. Extraction of an epiploon


Cut off a knife an epiploon edge. By means of the screw-driver which is wrapped up by fabric take an epiploon (2.72).

NOTE
By means of an emery paper remove the epiploon remains from an edge of the holder of a back epiploon. Apply lubricant on a surface of a new epiploon. By means of a drift and the hammer press a new epiploon so that its surface did not support edge of an edge of the holder of a back epiploon.


Fig. 2.73. Order of an otvorachivaniye of bolts of fastening of an oil case


In several passes, consistently, turn off eleven bolts of fastening of a case (fig. 2.73).

"previous page
2.2.5.11. Removal of balancer shafts
following page"
2.2.5.13. Check of a chain of the drive of the mechanism of a gazorspredeleniye and asterisk of shaft