Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.2.1. General information and safety measures on removal of the power unit
2.2.2. Removal of sealant
2.2.3. The specification of types of the applied nuts and bolts
2.2.4. Service of a mechanical part of the engine
2.2.5. General repair operations
2.2.6. Dismantling, check and assembly of a head of the block of cylinders
2.2.7. Dismantling, check and assembly of the block of cylinders
2.2.7.1. Dismantling of the block of cylinders
2.2.7.2. Check of a radial side play of the conrod bearing
2.2.7.3. Replacement of inserts of radical bearings
2.2.7.4. Removal of the piston and rod assembled
2.2.7.5. Measurement of axial and radial side plays of a bent shaft and in radical bearings
2.2.7.6. Check of a gap between the piston and the cylinder
2.2.7.7. Check of a gap between a compression ring and a flute
2.2.7.8. Check of a gap in the lock of a piston finger
2.2.7.9. Check of internal diameter of an opening under a finger in the piston
2.2.7.10. Check of diameter of a piston finger
2.2.7.11. Check of landing of a piston finger
2.2.7.12. Check of a rod
2.2.7.13. Check of a kolnchaty shaft
2.2.7.14. Check of conrod and radical necks
2.2.7.15. Check of conrod bolts
2.2.7.16. Check and replacement of inserts of radical bearings
2.2.7.17. Assembly of conrod and piston group
2.2.7.18. Installation of piston rings
2.2.7.19. Installation of inserts of conrod bearings
2.2.7.20. Assembly of the block of cylinders
2.2.8. General assembly
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-2-7-10-proverka-diametra-porshnevogo-palca.html

2.2.7.10. Check of diameter of a piston finger

Fig. 2.114. Measurement of diameter of a piston finger


Using a micrometer, measure diameter of a piston finger (fig. 2.114).
Standard diameter – 21,997–22,009 mm.
Extreme diameter – 21,990 mm.

"previous page
2.2.7.9. Check of internal diameter of an opening under a finger in the piston
following page"
2.2.7.11. Check of landing of a piston finger