Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.2.1. General information and safety measures on removal of the power unit
2.2.2. Removal of sealant
2.2.3. The specification of types of the applied nuts and bolts
2.2.4. Service of a mechanical part of the engine
2.2.5. General repair operations
2.2.6. Dismantling, check and assembly of a head of the block of cylinders
2.2.7. Dismantling, check and assembly of the block of cylinders
2.2.7.1. Dismantling of the block of cylinders
2.2.7.2. Check of a radial side play of the conrod bearing
2.2.7.3. Replacement of inserts of radical bearings
2.2.7.4. Removal of the piston and rod assembled
2.2.7.5. Measurement of axial and radial side plays of a bent shaft and in radical bearings
2.2.7.6. Check of a gap between the piston and the cylinder
2.2.7.7. Check of a gap between a compression ring and a flute
2.2.7.8. Check of a gap in the lock of a piston finger
2.2.7.9. Check of internal diameter of an opening under a finger in the piston
2.2.7.10. Check of diameter of a piston finger
2.2.7.11. Check of landing of a piston finger
2.2.7.12. Check of a rod
2.2.7.13. Check of a kolnchaty shaft
2.2.7.14. Check of conrod and radical necks
2.2.7.15. Check of conrod bolts
2.2.7.16. Check and replacement of inserts of radical bearings
2.2.7.17. Assembly of conrod and piston group
2.2.7.18. Installation of piston rings
2.2.7.19. Installation of inserts of conrod bearings
2.2.7.20. Assembly of the block of cylinders
2.2.8. General assembly
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-2-7-3-zamena-vkladyshejj-korennykh-podshipnikov.html

2.2.7.3. Replacement of inserts of radical bearings

Fig. 2.99. Marking of dimensional group of inserts of radical bearings


When replacing inserts of the standard size it is necessary to use inserts of one dimensional group specified on a bearing cover. There are dimensional groups of inserts designated by "1", "2", "3" (fig. 2.99).
Internal diameter of the lower head of a rod:
marking "1"..... 51,000–51,007 mm;
marking "2"..... 51,008–51,013 mm;
marking "3"    ..... 51,014–51,020 mm.
The standard sizes of inserts on their thickness:
marking "1"    ..... 1,485–1,488 mm;
marking "2"    ..... 1,488–1,491 mm;
marking "3"    ..... 1,491–1,494 mm.
Remove the remains of a calibration wire from the working surfaces of a neck and an insert.

"previous page
2.2.7.2. Check of a radial side play of the conrod bearing
following page"
2.2.7.4. Removal of the piston and rod assembled