Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.2.1. General information and safety measures on removal of the power unit
2.2.2. Removal of sealant
2.2.3. The specification of types of the applied nuts and bolts
2.2.4. Service of a mechanical part of the engine
2.2.5. General repair operations
2.2.6. Dismantling, check and assembly of a head of the block of cylinders
2.2.7. Dismantling, check and assembly of the block of cylinders
2.2.7.1. Dismantling of the block of cylinders
2.2.7.2. Check of a radial side play of the conrod bearing
2.2.7.3. Replacement of inserts of radical bearings
2.2.7.4. Removal of the piston and rod assembled
2.2.7.5. Measurement of axial and radial side plays of a bent shaft and in radical bearings
2.2.7.6. Check of a gap between the piston and the cylinder
2.2.7.7. Check of a gap between a compression ring and a flute
2.2.7.8. Check of a gap in the lock of a piston finger
2.2.7.9. Check of internal diameter of an opening under a finger in the piston
2.2.7.10. Check of diameter of a piston finger
2.2.7.11. Check of landing of a piston finger
2.2.7.12. Check of a rod
2.2.7.13. Check of a kolnchaty shaft
2.2.7.14. Check of conrod and radical necks
2.2.7.15. Check of conrod bolts
2.2.7.16. Check and replacement of inserts of radical bearings
2.2.7.17. Assembly of conrod and piston group
2.2.7.18. Installation of piston rings
2.2.7.19. Installation of inserts of conrod bearings
2.2.7.20. Assembly of the block of cylinders
2.2.8. General assembly
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-2-7-7-proverka-zazora-mezhdu-kompressionnym-kolcom-i-kanavkojj.html

2.2.7.7. Check of a gap between a compression ring and a flute

Fig. 2.110. Measurement of a gap between a compression ring and a flute


Check a gap between a compression ring and a flute, having measured it by the flat probe, as shown in the figure 2.110.
Standard gap:
compression ring No. 1 – 0,020–0,070 mm;
compression ring No. 2 – 0,020–0,060 mm;
oil scraper ring:
1AZ-FE – 0,070–0,150 mm;
2AZ-FE – 0,070–0,150 mm.

NOTE
For an oil scraper ring the gap is determined by scrapers. If the gap is more than admissible, replace the piston.

"previous page
2.2.7.6. Check of a gap between the piston and the cylinder
following page"
2.2.7.8. Check of a gap in the lock of a piston finger