Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.4.1. Service of a mechanical part of the engine
2.4.2. Check and adjustment of thermal gaps in valves
2.4.2.1. Beginning of work
2.4.2.2. Removal of a cover of a head of the block of cylinders
2.4.2.3. Installation of the piston of the 1st cylinder in compression step VMT
2.4.2.4. Check of thermal gaps in valves
2.4.2.5. Adjustment of thermal gaps in valves
2.4.3. Removal, check and installation of a belt of the drive of the mechanism of gas distribution (GRM)
2.4.4. Removal of a head of the block of cylinders
2.4.5. Dismantling of a head of the block of cylinders
2.4.6. Assembly of a head of the block of cylinders
2.4.7. Installation of a head of the block of cylinders
2.4.8. Dismantling, check and assembly of the block of cylinders
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-4-2-2-snyatie-kryshki-golovki-bloka-cilindrov.html

2.4.2.2. Removal of a cover of a head of the block of cylinders

Fig. 2.222. Removal of protection of an electrical wiring


Disconnect two hoses of system of ventilation of a case from a cover of a head of the block of cylinders. Disconnect two clips of protection of a plait of wires against bolts of fastening of a cover No. 2 of a belt of the GRM drive. Turn off four nuts, remove consolidation of tubes of spark plugs. Turn off two nuts in a forward part of the engine and disconnect protection of an electrical wiring against a forward head of the block of cylinders (fig. 2.222).
Uncover a head of the block of cylinders and laying.

NOTE
To minimize oil leak, arrange consolidations of tubes of spark plugs in the sequence of removal for the subsequent their correct installation.

"previous page
2.4.2.1. Beginning of work
following page"
2.4.2.3. Installation of the piston of the 1st cylinder in compression step VMT