Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.4.1. Service of a mechanical part of the engine
2.4.2. Check and adjustment of thermal gaps in valves
2.4.3. Removal, check and installation of a belt of the drive of the mechanism of gas distribution (GRM)
2.4.4. Removal of a head of the block of cylinders
2.4.5. Dismantling of a head of the block of cylinders
2.4.5.1. Removal of valves
2.4.5.2. Cleaning of a head of the block of cylinders
2.4.5.3. Check of a head of the block of cylinders on a buckling
2.4.5.4. Replacement of the valve and the directing plug
2.4.5.5. Check and grinding in of valves
2.4.5.6. Check of a valvate spring
2.4.5.7. Check of a pusher of the valve
2.4.5.8. Check of an axial side play of the camshaft
2.4.5.9. Measurement of a gap in gear gearing of camshafts
2.4.5.10. Check of boring under pushers in the block head case
2.4.5.11. Check of an oil gap in camshaft bearings
2.4.6. Assembly of a head of the block of cylinders
2.4.7. Installation of a head of the block of cylinders
2.4.8. Dismantling, check and assembly of the block of cylinders
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-4-5-8-proverka-osevogo-lyufta-raspredelitelnogo-vala.html

2.4.5.8. Check of an axial side play of the camshaft

Fig. 2.281. Check of an axial side play of the camshaft


Install the camshaft in a bed of a head of the block of cylinders. The indicator measure an axial gap when moving camshafts (fig. 2.281) back and forth.
Axial gap
camshafts:
standard – 0,040–0,090 mm;
the most admissible – 0,12 mm.
The most admissible:
inlet – 0,12 mm;
final – 0,10 mm.
If the axial gap is more than most admissible, replace the camshaft. If it is necessary, replace covers of the bearing and a head of the block of cylinders.

"previous page
2.4.5.7. Check of a pusher of the valve
following page"
2.4.5.9. Measurement of a gap in gear gearing of camshafts