Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.4.1. Service of a mechanical part of the engine
2.4.2. Check and adjustment of thermal gaps in valves
2.4.3. Removal, check and installation of a belt of the drive of the mechanism of gas distribution (GRM)
2.4.4. Removal of a head of the block of cylinders
2.4.5. Dismantling of a head of the block of cylinders
2.4.6. Assembly of a head of the block of cylinders
2.4.7. Installation of a head of the block of cylinders
2.4.8. Dismantling, check and assembly of the block of cylinders
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-4-6-sborka-golovki-bloka-cilindrov.html

2.4.6. Assembly of a head of the block of cylinders

NOTE
Before assembly clear all details which will gather. Apply fresh engine oil on all rubbing surfaces. Replace all laying and epiploons.


Fig. 2.286. Press fitting of a new tube of a spark plug


Establish new tubes of spark plugs. Apply glue on spark plug tubes. Press a new tube of a spark plug so that she acted on 42,4–43,4 mm from the plane of the socket of a head of the block of cylinders (fig. 2.286).

Fig. 2.287. Press fitting new tubes of system of ventilation of a case


Using a wooden plate and the hammer, press also new tubes of system of ventilation of a case so that they were flush with the plane of the socket of a head of the block of cylinders (fig. 2.287).

Fig. 2.288. Installation of new oil scraper caps: 1 – special adaptation


By means of suitable adaptation establish new oil scraper caps (fig. 2.288).

Fig. 2.289. Marking of new oil scraper caps


The rubber condensing covering is applied on oil scraper caps of inlet valves. Oil scraper caps of inlet valves are painted in gray or brown color, and oil scraper caps of final valves – in black color (fig. 2.289).
Establish the following details:
valve;
valve spring saddle;
valve spring;
plate of a spring;
crackers.
By means of suitable adaptation squeeze a valvate spring and establish two crackers around a valve core. Slightly strike with the hammer with a plastic head a valve core end face to provide reliable fixing of the valve with crackers. Establish pushers of valves and adjusting washers; be convinced that pushers rotate freely by hand.

"previous page
2.4.5.11. Check of an oil gap in camshaft bearings
following page"
2.4.7. Installation of a head of the block of cylinders