Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.4.1. Service of a mechanical part of the engine
2.4.2. Check and adjustment of thermal gaps in valves
2.4.3. Removal, check and installation of a belt of the drive of the mechanism of gas distribution (GRM)
2.4.4. Removal of a head of the block of cylinders
2.4.5. Dismantling of a head of the block of cylinders
2.4.6. Assembly of a head of the block of cylinders
2.4.7. Installation of a head of the block of cylinders
2.4.7.1. Assembly of camshafts of final valves
2.4.7.2. Installation of camshafts of final valves
2.4.7.3. Installation of the camshaft of inlet valves of a back head of the block
2.4.7.4. Installation of the camshaft of final valves of a back head of the block
2.4.7.5. Installation of the camshaft of inlet valves of a forward head of the block
2.4.7.6. Installation of a cover of heads of the block of cylinders
2.4.7.7. Installation of other components
2.4.8. Dismantling, check and assembly of the block of cylinders
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-4-7-3-ustanovka-raspredelitelnogo-vala-vpusknykh-klapanov-zadnejj-golovki-bloka.html

2.4.7.3. Installation of the camshaft of inlet valves of a back head of the block

Fig. 2.297. Combination of tags of gear wheels of the drive of the camshaft


Apply a layer of engine oil on the face persistent surfaces of the camshaft. Enter into gearing of a gear wheel of the drive of camshafts of final and inlet valves, having combined with each other adjusting tags (two points) on gear wheels. Install the camshaft of inlet valves on a head of the block of cylinders (fig. 2.297).

Fig. 2.298. Marking of covers of bearings


Establish covers of bearings according to marking on their cases (fig. 2.298).

Fig. 2.299. Order of tightening of bolts of fastening of covers of bearings


Apply a thin film of engine oil on a carving and under heads of bolts of fastening of covers of bearings. Establish and evenly tighten ten bolts of fastening of covers of bearings in several passes the moment of an inhaling of 16 N · m in the sequence shown in the figure 2.299.
Turn off a technological bolt.

"previous page
2.4.7.2. Installation of camshafts of final valves
following page"
2.4.7.4. Installation of the camshaft of final valves of a back head of the block