Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
2.1. Petrol engines models 1AZ-FE and 2AZ-FE
2.2. Mechanical part of engines of models 1AZ-FE and 2AZ-FE
2.3. Petrol engine of model 1MZ-FE
2.4. Mechanical part of the engine of model 1MZ-FE
2.4.1. Service of a mechanical part of the engine
2.4.2. Check and adjustment of thermal gaps in valves
2.4.3. Removal, check and installation of a belt of the drive of the mechanism of gas distribution (GRM)
2.4.4. Removal of a head of the block of cylinders
2.4.5. Dismantling of a head of the block of cylinders
2.4.6. Assembly of a head of the block of cylinders
2.4.7. Installation of a head of the block of cylinders
2.4.7.1. Assembly of camshafts of final valves
2.4.7.2. Installation of camshafts of final valves
2.4.7.3. Installation of the camshaft of inlet valves of a back head of the block
2.4.7.4. Installation of the camshaft of final valves of a back head of the block
2.4.7.5. Installation of the camshaft of inlet valves of a forward head of the block
2.4.7.6. Installation of a cover of heads of the block of cylinders
2.4.7.7. Installation of other components
2.4.8. Dismantling, check and assembly of the block of cylinders
2.5. Appendix
2.6. Tables
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

2-4-7-ustanovka-golovki-bloka-cilindrov.html

2.4.7. Installation of a head of the block of cylinders




Install heads of the block of cylinders on the block of cylinders, previously having established on it new laying of heads.
Establish bolts of a head of the block of cylinders.

NOTE
Bolts of fastening of a head of the block of cylinders drag on in two stages. If any bolt of fastening of a head of the block of cylinders is broken or deformed, replace it.


Fig. 2.260. An order of an otvorachivaniye of bolts with an internal hexagon on each head of the block of cylinders


Apply a thin film of engine oil on a carving and under heads of bolts of fastening. Establish washers on fastening bolts. Establish and evenly tighten ten bolts of fastening of a head of the block of cylinders in several passes the moment of an inhaling of 54 N · m (see fig. 2.260).
If at an inhaling of any bolt the required inhaling moment is not reached, replace a bolt. Apply tags with paint on a forward part of bolts of a head of the block of cylinders. Tighten bolts of a head of the block of cylinders on 90 ° in the sequence stated above. Check that the tag put with paint costs on 90 ° from initial situation.
Establish bolts of a head of the block of cylinders with an internal hexagon. Apply a thin film of engine oil on a carving and under heads of bolts of fastening. Establish and tighten bolts of fastening of a head of the block of cylinders with an internal hexagon a key on 8 mm the moment of an inhaling of 18 N · m.

"previous page
2.4.6. Assembly of a head of the block of cylinders
following page"
2.4.7.1. Assembly of camshafts of final valves