Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Replacement of a pedal of coupling
3.1.3. Removal and installation of the main cylinder of coupling
3.1.3.1. Removal of the main cylinder of coupling
3.1.3.2. Removal of a set of the piston of the main cylinder of coupling
3.1.3.3. Installation of a set of the piston of the main cylinder of coupling
3.1.3.4. Installation of the main cylinder of coupling
3.1.4. The intermediate accumulator of coupling (is established since July, 2003)
3.1.5. Removal and installation of the working cylinder of coupling
3.1.6. Removal, check and installation of coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

3-1-3-4-ustanovka-glavnogo-cilindra-scepleniya.html

3.1.3.4. Installation of the main cylinder of coupling

Fig. 3.26. Places of putting jellied lubricant on the surface of contact of a pin and the plug


Apply jellied MP lubricant on the surfaces of contact of a pin and the plug (fig. 3.26).
Connect a fork to a coupling pedal a pin.

NOTE
Establish a pin on the left side of the vehicle.

Establish a pin clip.
Using special adaptation, connect a flexible hose and tighten a fastening nut.
Inhaling moment: 15,2 N · m.
Connect a tube of a tank of the main cylinder of coupling with a clip to the main cylinder of coupling.

ATTENTION
Connect a tube of a tank of the main cylinder of coupling so that it was not bent.

Establish the amplifier of brakes.
Install the main brake cylinder.

Fig. 3.27. Removal of air from the main cylinder


Remove air from the main cylinder (fig. 3.27).

Fig. 3.28. Removal of air from the brake system


Remove air from the brake system (fig. 3.28).

Fig. 3.29. Filling of a tank of the main brake cylinder with liquid for coupling


Having filled a tank of the main brake cylinder with liquid for coupling, remove air from system of coupling (fig. 3.29).
Check and adjust brake pedal height.
Check and adjust a coupling pedal assembled.
Check leak of brake fluid.
Check leak of liquid for coupling.
Check liquid level in a coupling hydraulic actuator tank.

"previous page
3.1.3.3. Installation of a set of the piston of the main cylinder of coupling
following page"
3.1.4. The intermediate accumulator of coupling (is established since July, 2003)