Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Replacement of a pedal of coupling
3.1.3. Removal and installation of the main cylinder of coupling
3.1.4. The intermediate accumulator of coupling (is established since July, 2003)
3.1.5. Removal and installation of the working cylinder of coupling
3.1.6. Removal, check and installation of coupling
3.1.6.1. Removal
3.1.6.2. Check
3.1.6.3. Installation
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

3-1-6-3-ustanovka.html

3.1.6.3. Installation

Fig. 3.40. Installation of a clutch plate on a flywheel


Insert the special device in a clutch plate, then establish a disk on a flywheel (fig. 3.40).

Fig. 3.41. Order of tightening of bolts of fastening of a casing of coupling


Combine assembly tags on a casing of coupling and a flywheel. Tighten 6 bolts, since the bolt located about a pin from above. Working in the order shown in the figure 3.41 at the same time evenly tighten bolts.
Inhaling moment: 19,1 N · m.

NOTE
With Ottsentriuyte the provision of a disk, slightly moving special adaptation up, down, to the right and to the left.


Fig. 3.42. Check of alignment of petals of a diaphragm spring


Using the indicator of hour type with a roller, check alignment of petals of a diaphragm spring (fig. 3.42).
Maximum discrepancy: 0,5 mm.
To install a support of a fork of switching off of coupling in the transmission.
Inhaling moment: 47,1 N · m.
Install a clip of the coupling of the bearing of switching off of coupling on the bearing.

Fig. 3.43. Places of putting jellied lubricant on forks of switching off of coupling, a fork and a pusher and a point of support of a fork


Apply jellied lubricant on the surfaces of contact of the coupling and a fork of switching off of coupling, a fork and a pusher and a point of support of a fork (fig. 3.43).
Apply jellied lubricant for shlitsevy connections of coupling and on vents of the leading shaft.
Lubricant: No. according to the catalog 08887-01806, jellied lubricant for the coupling of switching off of coupling or its equivalent.
Install a fork of switching off of coupling with the bearing of switching off of coupling in the transmission.

NOTE
After installation move a fork for check of smoothness of movement of the release bearing forward and back.

Establish a coupling switching off fork cover.
Install the transmission.

"previous page
3.1.6.2. Check
following page"
3.2. Mechanical transmission