Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.2.1. General information
3.2.2. Check of level of oil of the mechanical transmission
3.2.3. Components of the mechanical transmission in the block with the main transfer
3.2.4. Replacement of a forward epiploon of differential
3.2.5. Repair of differential
3.2.5.1. Removal of a box of differential
3.2.5.2. Check of a district gap of semi-axial gear wheels
3.2.5.3. Removal of a pin of an axis and axis of satellites of differential
3.2.5.4. Removal of a forward semi-axial gear wheel of differential
3.2.5.5. Assembly
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

3-2-5-5-sborka.html

3.2.5.5. Assembly

Cover the surface of rotation of a semi-axial gear wheel with gearbox oil.
Establish 2 persistent washers of semi-axial gear wheels on 2 semi-axial gear wheels.

NOTE
Establish a semi-axial gear wheel of the same thickness, as well as at removed.

Establish 2 semi-axial gear wheels, 2 satellites of differential and 2 persistent washers of semi-axial gear wheels in a differential box. Rotating differential satellites, install 2 satellites of differential with washers.
Cover the surfaces of rotation of an axis of satellites of differential No. 1 with gearbox oil.
Establish an axis of satellites of differential No. 1 in a differential box so that the opening of a pin of an axis of satellites coincided with an opening in a differential box.
Using small beards with a thin sting and the hammer, establish a pin of an axis of satellites of differential in a differential box opening.

Fig. 3.69. Measurement of a district gap of semi-axial gear wheels


Drive the differential satellite into the corner of a differential box. Using the indicator of hour type, measure a district gap of semi-axial gear wheels (fig. 3.69).
Standard district gap: 0,05–0,2 mm.
If the district gap does not meet standard, adjust a gap selection of a persistent washer of a semi-axial gear wheel.

Persistent washer, mm


Fig. 3.70. Heating of a gear wreath in a special bathtub


Using the heater, heat a gear wreath to 90–100 °C (fig. 3.70).
Clear the surfaces of contact of a box of differential.
Having combined tags, quickly establish a gear wreath on a differential box.
Inhaling moment: 106 N · m.
Establish a gear wheel of the drive of a speedometer (MTM) on a differential box.

"previous page
3.2.5.4. Removal of a forward semi-axial gear wheel of differential
following page"
3.3. Automatic transmission