Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Check on the car
3.4.3. Components of the driving mechanism
3.4.4. Repair of a nave and rotary fist of a forward wheel
3.4.4.1. Removal
3.4.4.2. Installation
3.4.5. Replacement of a bolt of a nave of a forward wheel
3.4.6. Removal and installation of a nave of a back wheel
3.4.7. Removal and installation of a rotary fist of a nave of a back wheel
3.4.8. Replacement of a bolt of a nave of a back wheel
3.4.9. Dismantling of the drive of a forward wheel
3.5. Tables
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

3-4-4-2-ustanovka.html

3.4.4.2. Installation

Using special adaptation 09950-60020 and a press, install the new hug bearing of a forward wheel in a rotary fist.
Install the protection cover of a disk brake and by means of a wrench of Torx (T30), wrap 4 bolts.

Fig. 3.147. Installation of the new hug bearing of a forward wheel


Fig. 3.148. Installation of a nave of a forward wheel


Using special adaptation and a press, establish a nave of a forward wheel (fig. 3.148).
Using the device for installation of lock rings, establish a new lock ring of an opening of a nave of a forward wheel.
Install the lower spherical hinge of a forward suspension bracket and tighten a nut.
Inhaling moment: 123 N · m.
Install the new forelock.

ATTENTION
If openings for the forelock do not coincide, wrap a nut further to 60 °.

Establish 2 bolts, nuts and a forward nave assembled on a damping rack of a forward suspension bracket.
Inhaling moment: 210 N · m.

NOTE
Insert a bolt from a forward part of the vehicle and tighten a nut.

Put forward a forward nave outside, combine a shlitsevy part of the drive of a forward wheel with an opening in a nave and insert the drive of a forward wheel into a nave.

ATTENTION
Do not put forward a forward nave too far.
You watch to damaging a cover of the external hinge.
You watch to damaging ABS speed sensor rotor.

Install the lower lever of a forward suspension bracket No. 1.
Establish steering draft.
Establish a forward disk.
Establish a support of a disk brake and fix it by two bolts to a rotary fist.
Inhaling moment: 106,9 N · m.
Establish a nut of a nave of a forward wheel.
Disconnect a support of a disk brake and carry out the check of a gap of the hug bearing and other checks described above in the subsection "Check on the Car".
Finalize a support of a disk brake on a rotary fist and fix it by 2 bolts.
Install the forward sensor of speed.
Establish a forward wheel.
Inhaling moment: 103 N · m.
Check and adjust the angles of installation of forward wheels.
Check ABS speed sensor signal.

"previous page
3.4.4.1. Removal
following page"
3.4.5. Replacement of a bolt of a nave of a forward wheel