Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.1.1. Preliminary checks
4.1.2. Measurement of clearance of forward and zadnkhy wheels of the car
4.1.3. Check and adjustment of corners of a convergence of wheels
4.1.4. Check and adjustment of angles of rotation of wheels
4.1.5. Check of disorder, longitudinal and cross inclination of axes of turn
4.1.6. Adjustment of disorder
4.2. Forward and back suspension brackets
4.3. Tables
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

4-1-6-regulirovka-razvala.html

4.1.6. Adjustment of disorder

ATTENTION
After adjustment of disorder check a corner of a convergence of forward wheels again.

Remove forward wheels and a collar of the sensor of frequency of rotation (ABS).

Fig. 4.9. Nuts of fastening of the lower party of a rack


Turn off two nuts of fastening from the lower party of a rack (fig. 4.9).
Apply engine oil on a carving of nuts.
Temporarily establish nuts.

Fig. 4.10. Scheme of adjustment of disorder


Adjust disorder size, moving the lower part of a rack (fig. 4.10).
Establish average value of size of disorder. When using a bolt without tag adjustment of size of disorder is possible in the range from 0 °06’ to 0 °30’.
Tighten nuts.
Inhaling moment: 211 N · m.
Establish forward wheels.
Inhaling moment: 103 N · m.
Check disorder.
If disorder does not correspond to the set conditions, then by means of table 4.5 pick up a bolt and make adjustment.

"previous page
4.1.5. Check of disorder, longitudinal and cross inclination of axes of turn
following page"
4.2. Forward and back suspension brackets