Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.2. Forward and back suspension brackets
4.2.1. Forward and back suspension brackets – general information
4.2.2. Shock-absorber
4.2.3. Back suspension bracket
4.2.4. Components of a forward suspension bracket
4.2.5. Removal, check and installation of a damping rack of a forward suspension bracket
4.2.6. Removal, check and installation of the lower spherical support
4.2.7. Removal and installation of the stabilizer of cross stability of a forward suspension bracket
4.2.8. Components of a back suspension bracket
4.2.9. Removal, check and installation of a damping rack of a back suspension bracket
4.2.9.1. Removal
4.2.9.2. Check
4.2.9.3. Installation
4.3. Tables
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

4-2-9-3-ustanovka.html

4.2.9.3. Installation

Fig. 4.47. Installation of the lower insulator of a spring


Install the lower insulator of a spring as it is shown in the figure 4.47.
Install the compression course limiter on a rod.

Fig. 4.48. Compression of a spring преред installation


Using the special tool, squeeze a spring and establish it on a rack (fig. 4.48).

Fig. 4.49. Correct installation of a cup of the top support of a rack


Establish the top support of a rack as it is shown in the figure 4.49, and temporarily tighten a fastening nut.

Fig. 4.50. Orientation of a cup of the top support of a rack on tags


Orient a rack support cup as it is shown in the figure 4.50.

Fig. 4.51. Tightening of the central nut of the top support of a rack


Tighten the central nut of the top support of a rack, without removing the special tool squeezing a spring of the shock-absorber (fig. 4.51).
Inhaling moment: 49 N · m.
Remove the special tool.
Tighten 3 nuts of fastening of the top support of a rack.
Inhaling moment: 39 N · m.

PRIMECHANE
After removal of the special tool, check correctness of installation of the top support again

Tighten two nuts of fastening from the lower party of a rack of the shock-absorber.
Inhaling moment: 255 N · m.

Fig. 4.52. Order of tightening of bolts of fastening of the holder of a brake hose and plait of wires of the sensor of frequency of rotation (ABS)


Tighten 2 bolts of fastening of the holder of a brake hose and a plait of wires of the sensor of frequency of rotation (ABS). Tighten them in the order specified in the figure 4.52.
Inhaling moment:
bolt of the holder of a brake hose: 19 N · m;
bolt of the holder of a plait of wires of the sensor of frequency of rotation (ABS): 5,5 N · m.
Install other components as it should be, the return to removal.
After installation check the angles of installation of back wheels.

"previous page
4.2.9.2. Check
following page"
4.3. Tables