Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
5.1. General information
5.2. Preliminary checks
5.2.1. Check of a side play of a steering wheel
5.2.2. Check of level of working liquid of the hydraulic booster
5.2.3. Check of pressure of working liquid of the hydraulic booster
5.2.4. Check of effort on a steering wheel
5.2.5. Pumping of system of the amplifier of steering
5.2.6. Steering mechanism components
5.2.7. Precautionary measures during the work with system of passive safety (SRS)
5.2.8. Removal and installation of a steering wheel and steering column
5.2.8.1. Removal of a steering wheel and finishing from the driver
5.2.8.2. Removal and check of a steering column
5.2.8.3. Check and replacement of the cylinder of the lock of ignition
5.2.8.4. Assembly and installation of a steering column
5.2.9. Removal and installation of the pump of the hydraulic booster of steering
5.3. Tables
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

5-2-8-2-snyatie-i-proverka-rulevojj-kolonki.html

5.2.8.2. Removal and check of a steering column

Fig. 5.26. Tags on an intermediate shaft and a shaft of the steering mechanism


Apply tags on an intermediate shaft and a shaft of the steering mechanism (fig. 5.26).

Fig. 5.27. Bolts of fastening of an intermediate shaft


Turn off A. Otvernite's bolt a bolt In and remove an intermediate shaft assembled (fig. 5.27).
Inhaling moment: 35 N · m.

Fig. 5.28. Removal of a steering column


Disconnect sockets, turn off four nuts of fastening and remove a steering column assembled (fig. 5.28).

Fig. 5.29. Measurement of length of the leading shaft


Check a steering column regarding mechanical damages. Measure length of the leading shaft (fig. 5.29).
Standard length: 474,5 ± 1 mm.
If length does not correspond to specified, replace a steering column assembled.

Fig. 5.30. Drilling of bolts with a conic head


By means of the special tool drill bolts with a conic head and take them from an arm (fig. 5.30).

Fig. 5.31. Removal of spring rings of the conducted shaft


Using a dilator, remove spring rings of the conducted shaft of management (outer side and inside) (fig. 5.31).
Remove an ignition lock arm from a pipe of a steering column. At installation of the lock of ignition use new bolts with a conic head. Tighten them until heads are not cut off.

"previous page
5.2.8.1. Removal of a steering wheel and finishing from the driver
following page"
5.2.8.3. Check and replacement of the cylinder of the lock of ignition