Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.11.1. Visual check of thickness of blocks
6.11.2. Removal of brake shoes
6.11.3. Check of brake shoes
6.11.4. Check of a brake disk and components of the brake mechanism
6.11.5. Measurement of thickness of a brake disk
6.11.6. Measurement of a beating of a brake disk
6.11.7. Assembly
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-11-7-sborka.html

6.11.7. Assembly

Fig. 6.44. Installation of consolidation in the piston


Apply lithium lubricant for rubber on consolidations of the piston and install them in the case of the cylinder (fig. 6.44).

ATTENTION
At installation do not apply too big effort not to damage a detail.


Fig. 6.45. Installation of a spring ring and cover of the brake cylinder


Establish a spring ring of a cover of the brake cylinder and a cover (fig. 6.45).

Fig. 6.46. Installation of boots of the directing fingers


By means of a face key (19 mm) and the hammer establish boots of the directing fingers (fig. 6.46).
Previously grease boots with lithium lubricant.
Install the case of the brake cylinder on a brake drive and tighten fixing bolts.
Inhaling moment: 107 N · m.
Establish the directing fingers.
Establish brake shoes.
Establish a support.
Tighten fixing bolts.
Inhaling moment: 34 N · m.
Establish a brake hose and tighten a fastening nut.
Inhaling moment: 29 N · m.
Fill in brake fluid in a flank.
Check whether brake fluid from the main cylinder exudes.
Check tubes and hoses of the brake system.
Pump over brakes.
Establish wheels.

"previous page
6.11.6. Measurement of a beating of a brake disk
following page"
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support