Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.11.1. Visual check of thickness of blocks
6.11.2. Removal of brake shoes
6.11.3. Check of brake shoes
6.11.4. Check of a brake disk and components of the brake mechanism
6.11.5. Measurement of thickness of a brake disk
6.11.6. Measurement of a beating of a brake disk
6.11.7. Assembly
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-11-zamena-perednikh-tormoznykh-kolodok-snyatie-razborka-i-ustanovka-perednego-supporta.html

6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support




When the case of the cylinder is open, do not press a brake pedal, otherwise the piston will jump out. Do not damage a boot of the piston and do not allow hit of oil on a brake disk. When replacing blocks always replace also laying. If on laying there are traces of a rust or flaking of a rubber covering, replace them new. To turn off a connecting bolt there is no need, except for dismantling and replacement of a support assembled. In these cases suspend the cylinder case on a wire so that not to stretch a brake hose. You see off to extra earnings of frictional surfaces of brakes in case of boring or replacement of drums or disks, after replacement of brake shoes or frictional slips, and also if after the small run the pedal begins "to fail".

"previous page
6.10.5. Installation
following page"
6.11.1. Visual check of thickness of blocks