Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.12.1. Visual check of thickness of blocks
6.12.2. Check of brake shoes
6.12.3. Measurement of thickness of a brake disk
6.12.4. Measurement of a beating of a brake disk
6.12.5. Assembly
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-12-1-vizualnaya-proverka-tolshhiny-kolodok.html

6.12.1. Visual check of thickness of blocks

Check thickness of blocks. For this purpose lift the car, remove a wheel and look through a viewing opening in the cylinder case.
Minimum thickness of brake shoes: 1 mm.
Extreme wear: 2,0 mm.
Merge brake fluid.
Remove a forward wheel and temporarily fix a rim by two nuts.
Turn off a bolt and disconnect an arm of a brake hose.

Fig. 6.48. Weakening of bolts of fastening of a support


Holding the directing fingers, turn off bolts of fastening of a support (fig. 6.48).

Fig. 6.49. Support raising


Lift a support and fix it by a wire (fig. 6.49).
Remove two antiskripny springs, two brake shoes, two antiskripny laying holding lamellar inserts.

NOTE
Antiskripny springs and the holding inserts can be reused only in case of their sufficient elasticity, lack of deformation, cracks, a rust and other malfunctions.


Fig. 6.50. Removal of indicators of wear of blocks


By means of the screw-driver with a thin sting remove indicators of wear of blocks (fig. 6.50).
Turn off a bolt of fastening and uncover a support a bracket.
Remove two brake shoes with antiskripny laying and two holding lamellar inserts.

Fig. 6.51. Extraction from the case of a support of the directing fingers


Take the directing finger (fig. 6.51).

Fig. 6.52. Removal of the case of a support


Turn off 2 bolts and remove the support case from a brake disk (fig. 6.52).

Fig. 6.53. Removal of a cover of the brake cylinder


Using the screw-driver, remove a spring ring of a cover of the brake cylinder and a cover (fig. 6.53).
Place rags between the piston and the cylinder.

Fig. 6.54. Extraction of the piston from the cylinder


Using compressed air, remove the piston from the cylinder (fig. 6.54).

"previous page
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
following page"
6.12.2. Check of brake shoes