Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.13.1. Dismantling
6.13.2. Check
6.13.3. Assembly
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-13-1-razborka.html

6.13.1. Dismantling

NOTE
If the brake disk is removed hardly, scroll an adjusting gear wheel until the brake disk does not begin to rotate easily (fig. 6.62).


Fig. 6.63. Measurement of internal diameter of the brake drum


Measure the internal diameter of the brake drum (fig. 6.63).
If the drum has scratches, mechanical damages or the increased wear, then it can be chiseled to the most admissible internal diameter
Standard diameter: 170 mm
The most admissible: 171 mm

Fig. 6.64. Release of coupling springs


Release coupling springs of brake shoes of the parking brake (fig. 6.64).

Fig. 6.65. Removal of adjusting screws of brake shoes of the parking brake


Remove adjusting screws of brake shoes of the parking brake (fig. 6.65.)
Remove an expansion plate together with a spring.
Remove a spring of the holder, a saddle of a spring and the holder.
Disconnect a returnable spring and remove a forward block.
Delay a back block.
Remove a returnable spring from a back block.
Remove a spring of the holder, a saddle of a spring and the holder.
Disconnect a cable of the parking brake from the lever of the parking brake.

Fig. 6.66. Removal of the lever of the parking brake


Remove a lock washer and the lever of the parking brake (fig. 6.66).

"previous page
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
following page"
6.13.2. Check