Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.13.1. Dismantling
6.13.2. Check
6.13.3. Assembly
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-13-2-proverka.html

6.13.2. Check

Check the removed details for lack of wear, a rust or damages.

Fig. 6.67. Measurement of thickness of overlays of brake shoes


Measure thickness of overlays of brake shoes (fig. 6.67).
Standard thickness: 2,0 mm
Minimum admissible: 1,0 mm
If thickness of slips is less minimum or they have uneven wear, replace brake shoes.

NOTE
If at least one brake shoe demands replacement, it is necessary to replace all set.


Fig. 6.68. Check of density of a prileganiye of brake shoes to the brake drum


Check density of a prileganiye of an overlay of a brake shoe to a drum (fig. 6.68).
If contact between working surfaces bad, or make grinding of slips, or replace brake shoes.

Fig. 6.69. Measurement of a gap between a brake shoe and the lever of the parking brake


Using the probe, measure a gap between a brake shoe and the lever of the parking brake (fig. 6.69).
The most admissible gap: 0,35 mm.
If the gap does not correspond to specifications, pick up an adjusting washer of the necessary thickness, being guided by data in the table.

"previous page
6.13.1. Dismantling
following page"
6.13.3. Assembly