Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-15-snyatie-i-ustanovka-modulyatora-davleniya.html

6.15. Removal and installation of the modulator of pressure

Remove the right forward flap.
Turn off a bolt of fastening of an arm of hoses of the conditioner.

Fig. 6.74. A detachment of tubes from pressure modulator


Using the special tool, turn off 6 nuts of fastening and disconnect brake tubes from the modulator of pressure (fig. 6.74).
Disconnect two sockets.

Fig. 6.75. Removal of the modulator of pressure


Turn off two bolts and two nuts and remove the modulator assembled (fig. 6.75).
Turn off two nuts and disconnect the modulator from an arm.
Remove from the modulator two holders and three plugs.
Installation is made as it should be, the return to removal.
After installation fill a tank with brake fluid, pump over the brake system and check lack of leaks.
Check is made by means of a special diagnostic tester of DLC3.

"previous page
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
following page"
6.16. Removal and installation of a pedal of a brake