Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
6.1. General information
6.2. Anti-blocking system of brakes (ABS)
6.3. Check and adjustment of elements of the brake system
6.4. Check of level of brake fluid in a tank of a hydraulic actuator of working ormozny system
6.5. Brake hoses
6.6. Adjustment of a pedal of a brake
6.7. Removal of air from a hydraulic actuator of the working brake system
6.8. Check and adjustment of the parking brake
6.9. Removal, dismantling, assembly and installation of the main brake cylinder
6.9.1. Removal
6.9.2. Dismantling
6.9.3. Check and installation
6.10. Check, removal and installation of the vacuum amplifier of brakes
6.11. Replacement of front brake shoes, removal, dismantling and installation of a forward support
6.12. Replacement of back brake shoes, removal, dismantling and installation of a back support
6.13. Dismantling, check and assembly of the brake mechanism of the parking brake
6.14. Removal and installation of the sensor of speed of rotation of a forward wheel
6.15. Removal and installation of the modulator of pressure
6.16. Removal and installation of a pedal of a brake
6.17. Tables
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment




80e768f8

6-9-2-razborka.html

6.9.2. Dismantling

Using the screw-driver, push pistons on all course, turn off a lock bolt and remove ring consolidation.

NOTE
Wind the screw-driver with a plaster or an adhesive tape not to damage pistons and a mirror of the cylinder.

Fig. 6.26. Removal of a spring ring


Press the piston the screw-driver and by means of tonkogubets for removal of spring rings remove a spring ring (fig. 6.26).


Fig. 6.27. Extraction of the piston No. 1 with a spring


Turn off a lock piston bolt with laying and take the piston No. 1 with a spring, extending it it is strict on an axis without distortions (fig. 6.27).

NOTE
If to take the piston at an angle, it is possible to damage a cylinder mirror.


Fig. 6.28. Extraction of the piston No. 2


Put a rag on two wooden whetstones and easily strike with a cylinder flange whetstones until the piston No. 2 comes to light. Make sure that the distance (A) specified in the figure 6.28 from a rag to top of whetstones was not less than 100 mm.

"previous page
6.9.1. Removal
following page"
6.9.3. Check and installation