Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.2.1. Check of degree of state of charge of the battery
7.2.2. Charging of the rechargeable battery
7.2.3. Charging of completely discharged rechargeable battery
7.2.4. Care of the rechargeable battery
7.2.5. Storage of the rechargeable battery
7.2.6. Check of completely charged rechargeable battery
7.2.7. Removal and installation of the rechargeable battery
7.3. System of power supply
7.4. System of electrostart-up
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-2-6-proverka-polnostyu-zaryazhennojj-akkumulyatornojj-batarei.html

7.2.6. Check of completely charged rechargeable battery

Establish on the ampermeter (with a limit of measurement 0–5 мА and 0-5 A) the highest limit of measurement. Turn on the ampermeter between a minus conclusion of the battery and a cable of weight. Connect a plus wire of the ampermeter to a plus conclusion of the battery, a minus wire of the ampermeter – to a minus conclusion of the battery.
Switch off everything consumers of the electric power, close all doors and a luggage carrier, switch off a plafond of illumination of a motor compartment.
Switch a limit of measurement of the ampermeter towards reduction until any indications appear (admissible value makes 1–3 мА). Taking out one after another safety locks from the block of safety locks, disconnect consistently all electric chains. If at disconnection of one of chains of the indication fall to 0, then in this chain it is necessary to look for a malfunction source. Possible malfunctions: the rusting or polluted contacts of electric sockets, the ground wires, internal short circuit in electric equipment elements.
If in the chains of malfunction protected by safety locks it is not revealed, disconnect wires from the devices unprotected by safety locks: generator, starter, elements of system of ignition.
If at shutdown of one of the unprotected chains of the indication of the ampermeter fall to 0, repair or replace the corresponding element. At leakage of current in a starter or system of ignition always check (according to the scheme) the switch of ignition and starter.

"previous page
7.2.5. Storage of the rechargeable battery
following page"
7.2.7. Removal and installation of the rechargeable battery