Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.3. System of power supply
7.3.1. General information
7.3.2. Generator
7.3.2.1. Check on the car
7.3.2.2. Check of a belt of the drive of hinged units
7.3.2.3. Check of an electric chain of the generator without loading (idling)
7.3.3. Dismantling, check and assembly of the generator
7.4. System of electrostart-up
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-3-2-2-proverka-remnya-privoda-navesnykh-agregatov.html

7.3.2.2. Check of a belt of the drive of hinged units

Fig. 7.4. Example of wear of a belt of the drive of hinged units


Check a belt of the drive of hinged units for wear and damages. At detection of defects replace a belt (fig. 7.4).

NOTE
Are not allowed peeling of rubber from a cord on internal (from crests) and external belt surfaces, stripping or damage of a cord, peeling of a crest from the rubber basis, existence of cracks, peeling or wear on side surfaces of a belt and on side surfaces of crests of a belt. If necessary replace a belt.


Fig. 7.5. Check of a tension of a belt of the drive of hinged units


Check a belt tension. Tighten a bolt In, as shown in the figure 7.5, and measure a drive belt deflection.
Drive belt deflection:
new: 9,1–10,5 mm;
used: 11,0–13,5 mm.

NOTE
The term "used belt" belongs to the belt which worked more than 5 min.


Fig. 7.6. Check of correctness of installation of a belt of the drive


If the new belt was established, check correctness of its landing on pulleys. Check a hand in the bottom of pulleys whether there is no free flute on a pulley (fig. 7.6).
After installation of a belt start the engine and let's it work within 5 min., and then again check a belt tension.
If necessary adjust a tension (deflection) of a belt of the drive.

Fig. 7.7. Adjustment of a tension of a belt of the drive


Rotating adjusting bolts And yes With, adjust a belt tension, as shown in the figure 7.7.
Inhaling moment:
- bolt And: 17, 5 N · m;
- a bolt With: 58 N · m.

"previous page
7.3.2.1. Check on the car
following page"
7.3.2.3. Check of an electric chain of the generator without loading (idling)