Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.3. System of power supply
7.3.1. General information
7.3.2. Generator
7.3.3. Dismantling, check and assembly of the generator
7.3.3.1. Removal of the generator (model with the engine 1 and 2 AZ-FE)
7.3.3.2. Installation of the generator (model with the engine 1 and 2 AZ-FE)
7.3.3.3. Removal of the generator (model with the engine 1 MZ-FE)
7.3.3.4. Installation of the generator (model with the engine 1 MZ-FE)
7.3.3.5. Dismantling of the generator
7.3.3.6. Check of the relay regulator of tension
7.3.3.7. Check of a rotor
7.3.3.8. Check of contact rings
7.3.3.9. Check of the vypryamitelny block
7.3.3.10. Check of brushes
7.3.3.11. Check of bearings
7.3.3.12. Assembly of the generator
7.4. System of electrostart-up
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-3-3-6-proverka-rele-regulyatora-napryazheniya.html

7.3.3.6. Check of the relay regulator of tension

Fig. 7.22. Check of the relay regulator of tension


Using an ohmmeter, check conductivity between F and B diodes (fig. 7.22).

ATTENTION
When positive and negative poles between clips of F and V are connected in a uniform chain, conductivity has to be only in one direction. If the continuity is in both directions, perhaps one of diodes is punched. In this case replace tension regulator.

Using an ohmmeter, check conductivity between diodes F and E.

"previous page
7.3.3.5. Dismantling of the generator
following page"
7.3.3.7. Check of a rotor