Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.3. System of power supply
7.3.1. General information
7.3.2. Generator
7.3.3. Dismantling, check and assembly of the generator
7.3.3.1. Removal of the generator (model with the engine 1 and 2 AZ-FE)
7.3.3.2. Installation of the generator (model with the engine 1 and 2 AZ-FE)
7.3.3.3. Removal of the generator (model with the engine 1 MZ-FE)
7.3.3.4. Installation of the generator (model with the engine 1 MZ-FE)
7.3.3.5. Dismantling of the generator
7.3.3.6. Check of the relay regulator of tension
7.3.3.7. Check of a rotor
7.3.3.8. Check of contact rings
7.3.3.9. Check of the vypryamitelny block
7.3.3.10. Check of brushes
7.3.3.11. Check of bearings
7.3.3.12. Assembly of the generator
7.4. System of electrostart-up
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-3-3-8-proverka-kontaktnykh-kolec.html

7.3.3.8. Check of contact rings

Check working surfaces of contact rings. On them there should not be agnails or chips.

Fig. 7.25. Measurement of diameter of contact rings


Measure by a caliper diameter of contact rings (fig. 7.25).
Standard diameter: 14,2–14,4 mm.
Minimum admissible: 12,8 mm.
If diameter of contact rings is less minimum admissible, the rotor needs to be replaced.

"previous page
7.3.3.7. Check of a rotor
following page"
7.3.3.9. Check of the vypryamitelny block