Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.3. System of power supply
7.4. System of electrostart-up
7.4.1. General information
7.4.2. New starter of the PS Camry car
7.4.3. Removal and installation of a starter
7.4.4. Check of work of a starter
7.4.5. Dismantling, check and assembly of a starter
7.4.5.1. Dismantling
7.4.5.2. Check of an anchor
7.4.5.3. Check of a collector
7.4.5.4. Check of the brush holder
7.4.5.5. Check of the traction relay
7.4.5.6. Assembly of a starter
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-4-5-1-razborka.html

7.4.5.1. Dismantling

Remove from the case of the traction relay the starter case assembled with a winding of a starter and an anchor.

Fig. 7.41. Removal of the plug of a wire of the traction relay


Turn off a nut and disconnect the wire plug from a conclusion of the traction relay (fig. 7.41).

Fig. 7.42. Bolts of fastening of a cover of a starter from the drive


Turn off two bolts of fastening of a cover of a starter (fig. 7.42).
Uncover a starter from the drive.
Extend the starter case assembled with a winding of the stator and an anchor from the case of the traction relay.

Fig. 7.43. Extraction of a spring ring


Using tonkogubets, take a spring ring (fig. 7.43).

Fig. 7.44. Bolts of fastening of a cover of a starter from the switchboard


Turn off two coupling bolts of fastening of a cover of a starter from the switchboard (fig. 7.44).
Uncover the party of the switchboard.

Fig. 7.45. Extraction of a steel ball from an opening in the roller of the obgonny coupling


By means of a magnetic core take a steel ball from an opening in the roller of the obgonny coupling (fig. 7.45).

Fig. 7.46. Removal of the brush holder


By means of the screw-driver wring out a spring of a brush and disconnect a brush from the brush holder. Disconnect four brushes and remove the brush holder (fig. 7.46).
Make sure that positive (+) the wire is not closed on weight.
Take an anchor from the starter case.

"previous page
7.4.5. Dismantling, check and assembly of a starter
following page"
7.4.5.2. Check of an anchor