Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.3. System of power supply
7.4. System of electrostart-up
7.4.1. General information
7.4.2. New starter of the PS Camry car
7.4.3. Removal and installation of a starter
7.4.4. Check of work of a starter
7.4.5. Dismantling, check and assembly of a starter
7.4.5.1. Dismantling
7.4.5.2. Check of an anchor
7.4.5.3. Check of a collector
7.4.5.4. Check of the brush holder
7.4.5.5. Check of the traction relay
7.4.5.6. Assembly of a starter
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-4-5-3-proverka-kollektora.html

7.4.5.3. Check of a collector

Examine working surfaces of lamels of a collector, at their pollution and burning smooth out working surfaces an emery paper No. 400 or pierce a collector on the lathe.

Fig. 7.49. Measurement of a beating of a collector


Establish an anchor on prisms and measure a beating of a collector (fig. 7.49).
Standard beating of a collector: 0,02 mm.
The most admissible beating of a collector: 0,05 mm.

Fig. 7.50. Measurement of size of a vystupaniye of edge of a collector


Measure by a caliper the size of a vystupaniye of edge of a collector (fig. 7.50).
Standard size of a vystupaniye: 3,3 mm.
The most admissible size of a vystupaniye: 4,0 mm.
If length exceeds the most admissible value, replace a starter anchor.

Fig. 7.51. Measurement of size of a vystupaniye of the brush holder


Measure by a caliper the size of a vystupaniye of the brush holder (fig. 7.51).
Standard size of a vystupaniye: 9,0 mm.
Minimum admissible size of a vystupaniye: 4,0 mm.
If length is less than minimum admissible value, replace the brush holder.

"previous page
7.4.5.2. Check of an anchor
following page"
7.4.5.4. Check of the brush holder