Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Rechargeable battery
7.3. System of power supply
7.4. System of electrostart-up
7.4.1. General information
7.4.2. New starter of the PS Camry car
7.4.3. Removal and installation of a starter
7.4.4. Check of work of a starter
7.4.5. Dismantling, check and assembly of a starter
7.4.5.1. Dismantling
7.4.5.2. Check of an anchor
7.4.5.3. Check of a collector
7.4.5.4. Check of the brush holder
7.4.5.5. Check of the traction relay
7.4.5.6. Assembly of a starter
7.5. Checks of onboard electric equipment
7.6. Tables
8. Body
9. Schemes of electric equipment




80e768f8

7-4-5-6-sborka-startera.html

7.4.5.6. Assembly of a starter

At assembly of a starter use high-temperature jellied lubricant for lubricant of bearings and gear wheels.
Grease with jellied lubricant a starter coupling shaft.
By means of tonkogubets establish a spring ring on a coupling shaft.

Fig. 7.54. Gap of a spring ring of a shaft of the coupling


Measure by a caliper a gap of a spring ring (fig. 7.54).
Minimum gap: 5,0 mm.
If the gap exceeds the specified size, replace a ring new.
Establish a starter cover from the switchboard.

Fig. 7.55. Combination of a cover of a starter with a cut on the case of the traction relay


Combine a ledge on a starter cover from the switchboard with a cut on the case of the traction relay (fig. 7.55).

Fig. 7.56. Final assembly of a starter


Level a cover assembled with the obgonny coupling and a cover from the switchboard and tighten two coupling bolts (fig. 7.56).
Carry out other assembly and installation as it should be, the return to removal.

"previous page
7.4.5.5. Check of the traction relay
following page"
7.5. Checks of onboard electric equipment