Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Features of a design of a body of the Camry car
8.3. Adjustment of hinged components of a body
8.4. Removal of hinged components and decorative overlays of a body
8.4.1. Removal of a front bumper
8.4.2. Removal of a rear bumper
8.4.3. Removal and installation of a back spoiler
8.4.3.1. Removal
8.4.3.2. Removal of a lamp of an additional signal of braking
8.4.3.3. Installation of a spoiler
8.4.4. Removal and installation of the top molding
8.4.5. Removal and installation of moldings of forward and back doors
8.4.6. Removal and installation of the lower molding
8.4.7. Removal and installation of a decorative overlay of a luggage carrier
8.4.8. Removal and installation of decorative emblems and fonts
8.5. Glasses
8.6. Headlights
8.7. Screen wipers
8.8. Conditioner and heater
8.9. Tables
9. Schemes of electric equipment




80e768f8

8-4-3-1-snyatie.html

8.4.3.1. Removal

NOTE
You make installation as it should be, the return to removal. If some actions for installation have distinctive features, then they are mentioned in appropriate section with the general name "Installation".

Having disconnected 15 clips of fastening, remove a trunk lid upholstery.
Turn off two nuts of fastening of a spoiler from the inside of a trunk lid.
Electrolamp heat a spoiler to temperature of 40-60 °C.

ATTENTION
Try not to heat a spoiler excessively.


Fig. 8.40. Removal of a glue basis of a back spoiler


Bring thin, strong thread under a contact surface of a spoiler. Carrying out by thread in all directions, as shown in the figure 8.40, try to make so that the warmed glue basis connecting a spoiler to a body completely departed from a body surface.

ATTENTION
During operation you seek not to damage a surface of a body and a spoiler.


Fig. 8.41. Clips of fastening of a back spoiler


Remove thread, disconnect two clips of fastening and remove a spoiler (fig. 8.41).

"previous page
8.4.3. Removal and installation of a back spoiler
following page"
8.4.3.2. Removal of a lamp of an additional signal of braking