Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Features of a design of a body of the Camry car
8.3. Adjustment of hinged components of a body
8.4. Removal of hinged components and decorative overlays of a body
8.4.1. Removal of a front bumper
8.4.2. Removal of a rear bumper
8.4.3. Removal and installation of a back spoiler
8.4.3.1. Removal
8.4.3.2. Removal of a lamp of an additional signal of braking
8.4.3.3. Installation of a spoiler
8.4.4. Removal and installation of the top molding
8.4.5. Removal and installation of moldings of forward and back doors
8.4.6. Removal and installation of the lower molding
8.4.7. Removal and installation of a decorative overlay of a luggage carrier
8.4.8. Removal and installation of decorative emblems and fonts
8.5. Glasses
8.6. Headlights
8.7. Screen wipers
8.8. Conditioner and heater
8.9. Tables
9. Schemes of electric equipment




80e768f8

8-4-3-3-ustanovka-spojjlera.html

8.4.3.3. Installation of a spoiler

Electrolamp heat a spoiler to temperature of 40-60 °C.
Clear the glue remains from a contact surface of a spoiler.

Fig. 8.43. The scheme of putting glue on a contact surface of a spoiler


Apply glue on a contact surface of a spoiler, as shown in the figure 8.43.
Heat a spoiler to 20–30 °C, and a body surface – to 40–60 °C.
Establish a spoiler into place, press and tighten two nuts of fastening.

"previous page
8.4.3.2. Removal of a lamp of an additional signal of braking
following page"
8.4.4. Removal and installation of the top molding