Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Features of a design of a body of the Camry car
8.3. Adjustment of hinged components of a body
8.4. Removal of hinged components and decorative overlays of a body
8.4.1. Removal of a front bumper
8.4.2. Removal of a rear bumper
8.4.3. Removal and installation of a back spoiler
8.4.4. Removal and installation of the top molding
8.4.4.1. Removal
8.4.4.2. Installation
8.4.5. Removal and installation of moldings of forward and back doors
8.4.6. Removal and installation of the lower molding
8.4.7. Removal and installation of a decorative overlay of a luggage carrier
8.4.8. Removal and installation of decorative emblems and fonts
8.5. Glasses
8.6. Headlights
8.7. Screen wipers
8.8. Conditioner and heater
8.9. Tables
9. Schemes of electric equipment




80e768f8

8-4-4-2-ustanovka.html

8.4.4.2. Installation

Remove with white spirit the glue remains from dredging on a surface of a roof of the car and shoot the film.
Electrolamp heat installation sites of clips to temperature of 40-60 °C.
Heat a molding to temperature of 20-30 °C.
Manually establish missing clips, apply new glue on a molding and establish a molding.

Fig. 8.45. Scheme of installation of the top molding


Press a molding to a roof, put from above a press and do not remove it during 24 h.

NOTE
The minimum time of maintenance of a molding under a press – 30 min.

"previous page
8.4.4.1. Removal
following page"
8.4.5. Removal and installation of moldings of forward and back doors