Tayota Kamri's repair since 2001
1. Operation manual and to maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Features of a design of a body of the Camry car
8.3. Adjustment of hinged components of a body
8.4. Removal of hinged components and decorative overlays of a body
8.5. Glasses
8.5.1. Removal and installation of a windshield
8.5.1.1. Removal
8.5.1.2. Installation
8.6. Headlights
8.7. Screen wipers
8.8. Conditioner and heater
8.9. Tables
9. Schemes of electric equipment




80e768f8

8-5-1-1-snyatie.html

8.5.1.1. Removal

Remove the following components:
– antisolar peaks and holders;
– the module of a plafond of illumination of salon and the regulator of provisions of the hatch on a roof;
– antisolar peaks and holders;
– top finishing of forward racks;
– cowl;
– screen wipers;
– forward protective apron;
– internal rear-view mirror.
Using a knife with a thin edge, remove a windshield sealant.

Fig. 8.51. Lines of a cut of a sealant of a windshield



NOTE
Not to damage glass, act as follows – cut off a sealant a knife on the lines shown in the figure 8.51. Remove the rest of a sealant hands.

Fig. 8.52. Types of fastening of stoppers of a molding



NOTE
There are two types of stoppers of a molding of a windshield. The type of fastening of each look is various. Pay attention to it at removal and installation of a windshield (fig. 8.52).


Fig. 8.53. Sites of installation of a cable for removal of a windshield


Stretch a string from salon and fix its ends on wooden whetstones (fig. 8.53).
Paste an adhesive tape on an external surface of a windshield not to scratch a surface.
At removal of glass try not to damage the painted surfaces and finishing.
Cut off a glue layer.
Remove glass.

Fig. 8.54. Removal of the remains of glue from a glass edge


By means of a scraper clear a glass edge of the remains of glue (fig. 8.54).
Wipe places where the glue remains were cleaned off by white spirit.

NOTE
Do not touch the fat-free surfaces.

Grease contact surfaces of the lower clamp with primer.

ATTENTION
Primer drying time not less than 3 min. You do not apply primer over glue. Open primer cannot be reused.

"previous page
8.5.1. Removal and installation of a windshield
following page"
8.5.1.2. Installation